Trad Talk Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 · (Edited)

·
Registered
Joined
·
3 Posts
Discussion Starter · #3 ·
Outerwear Sleeve Grey Collar Wood


Tire Automotive tire Automotive design Automotive lighting Helmet
Thanks, Im pretty new to the forums...this is my first lol. I will try again. The riser has a hard plastic piece that separates the limb from riser. Even has a neat little bear scene in the woods on it.
 

·
Premium Member
Joined
·
3,734 Posts
As is, the limb angles are too steep to work well, but there is enough meat there to recut them if you're up to the task. You'll probably have to remove and reinstall the limb bolt inserts to the appropriate angle too.
 

·
Premium Member
Joined
·
20,889 Posts
OK,,for a better guess on the best pocket angle I need your draw length and the length of the riser.

Now to further establish if it a suitable riser, I need you to measure the length and look in the exact center of that measurement and insure the center in the pivot point of the grip. If it is not, and it is higher? Not a good one..
 

·
Premium Member
Joined
·
20,889 Posts
OK the angles are fine on it like it is,,tell me,,what is the distance from the limb bolt center down to the bottom edge of the pocket?
 
1 - 7 of 7 Posts
Top