Trad Talk Forums banner
1 - 11 of 11 Posts

·
Premium Member
Joined
·
13,883 Posts
or some Sky Conquest limbs, too, same limb as Sky Jacks, but each limb 1/2" longer than regular ILF lengths.....1" longer per set.
 

·
Registered
Joined
·
456 Posts
Discussion Starter · #5 ·
Do Conquests fit in ILF risers? For some reason, I thought the bushings or the spacing was slightly different. But I’ve never seen Conquest limbs in person. If they do in fact fit a Gold Medalist riser, medium or long Conquests would also be fine.

My only stipulation really is no shorts, and 34 is probably my limit. Those 38’s ended up being 49 at my draw, which is just too much for me these days.
 

·
Premium Member
Joined
·
13,883 Posts
YES swap out CONQUEST fitting, insert DAS or ILF fitting. zero other changes.
Earl's presses only handled 24" risers, so to make the typical 66-68-70 inch target lengths, he made all Conquest sets of limbs 1" longer per set.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top